Lincoln Electric SVM134-A Connection of Lincoln Electric Wire Feeders, Connection of the LN-25 to

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

C-3			C-3
	ACCESSORIES
	CONNECTION OF LINCOLN
	ELECTRIC WIRE FEEDERS
	The Lincoln Electric LN-25 wire feeder is recommend-	3.	Connect the K444-2 remote control cable to the 14
	ed for wire feed welding with the Classic I.		pin amphenol on the Wire Feed Module.
		4.	Attach the single lead from the LN-25 control box
	CONNECTION OF THE LN-25 TO THE		to the work using the spring clip on the end of the
			lead. This is only a control lead — it carries no
	CLASSIC I “ACROSS THE ARC” WITH		welding current.
	WIRE FEED MODULE (SEE FIGURE C.1.)	5.	Place the IDLER switch in the “HIGH” position.
	1. Shut the welder off.	6.	Adjust wire feed speed and voltage at the LN-25.

2.Connect the electrode cable from the LN-25 to the “+” terminal of the welder. Connect the work cable to the “CV–” terminal of the welder.

NOTE: Welding cable must be sized for current and duty cycle of application.

NOTE: Figure C.1 shows the electrode connect- ed for positive polarity. To change polari- ty, shut the welder off and reverse the electrode and work cables at the Classic I output terminals. Reverse the LN-25 polarity switch.

FIGURE C.1

CLASSIC I/LN-25 ACROSS THE ARC CONNECTION DIAGRAM

14PIN AMPHENOL

+	LN-25 WIRE FEEDER
CV-	WITH K444-2 REMOTE
	VOLTAGE CONTROL OPTION

	ELECTRODE CABLE
TO	WORK CLIP
WORK	LEAD TO WORK

CLASSIC I