OPERATION |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
8.PULSE TIG CONTROL – The Pulse TIG feature built into the Precision TIG 185 is simplified to be a single knob control which sets the Pulse Frequency over the peak pulses/sec. range of about 0.1 to 20 pulses per second:
•Full CCW (min.) setting of the control knob shuts off Pulse TIG (0.0 pps).
•Peak Pulse level is set by the Max. Output Control and the Remote Amptrol (if used).
•Background Current level is typically optimized at a fixed 50% of Peak Pulse level setting.
•Peak Pulse %
A Green light "blinks" with each Peak Pulse to indi- cate the Pulse TIG Control setting before and during welding.
9.OVER TEMPERATURE LIGHT - 
If the welder overheats due to blocked air flow, high ambient air temperature, or exceeded duty cycle, an internal thermostat will open disabling the welding output and this yellow light will illuminate. The cooling fans will continue to run to cool the unit during this time. The light will go out when the unit cools and the thermostat resets. Once the light goes out, the machine will again become available to weld.
10.REMOTE RECEPTACLE – Provides for connec- tion of remote control and/or arc start switch only in TIG Mode: ( There is no remote output control capability when stick welding.
•Plugging a remote current control (Amptrol) into this receptacle automatically switches the output control from the panel Max Output Control (See Item 5) to the remote control.
•The connected remote control will then control the output current between the Min. range of the machine and the setting of the panel Max Output Control.
•Switching Mode Switch (See Item 3) to Stick will automatically disable the connected remote con- trol and switch the output control back to the Max Output panel control.
11.ELECTRODE/GAS OUTPUT RECEPTACLE - This quick connect
12.WORK CABLE - This work cable is factory con- nected to the welder and is connected to the work piece to complete the welding circuit. Refer to
Machine Grounding and High Frequency Interference Protection in the Installation section of this manual for the proper procedure on ground- ing the work clamp and work piece to minimize high frequency interference.
OPERATING STEPS
WELDING IN TIG MODE
1.Connect the TIG torch and cable
2.Set the TIG/STICK switch to “TIG”.
3.Set the Polarity Switch to DC- for welding steel or stainless steel; or to AC for welding aluminum.
4.Connect the Foot Amptrol to the Remote Control Connector.
5.Turn on the cylinder gas valve and adjust the flow regulator to obtain desired flow.
6.Turn the power switch to “ON”. NOTE: There will be a 15 second gas flow when the power is turned on.
7.Preset the Output Control on the control panel to the maximum desired amps, as read on the digital meter.
8.Depress the Foot Amptrol to energize the torch and establish an an arc with the work piece. The digital meter reads the actual amps while welding.
NOTE: When the TIG/STICK switch is set to “TIG”, depressing the remote control will start a 0.5 second gas
PULSE TIG CONTROL
Use this knob to set the frequency or the number of pulses per second(pps), from 0.1pps to 20pps.
•This setting adjusts heat output and bead shape for travel speed. Thinner plate that is welded with faster travel speed will require higher frequency than thick- er plate with slower travel speed.
