Section TOC
Master TOC
TROUBLESHOOTING & REPAIR |
HIGH VOLTAGE TRANSFORMER
REMOVAL AND REPLACEMENT PROCEDURE (Continued)
Return to
Return to Section TOC
Return to
Return to Master TOC
REPLACEMENT PROCEDURE
1.Carefully position the new high volt- age transformer in place in the two rear mounting insulators. See Figure F.12.
2.Install the front mounting insulators and mounting screw.
3.Using the phillips head screwdriver tighten all four mounting screws mak- ing certain the insulators are posi- tioned correctly.
4.Reconnect the two primary leads.
5.Reconnect the two secondary leads to the high frequency arc starter board assembly.
6.Replace any previously removed cable ties.
7.Replace the case
Return to Master TOC
FIGURE F.12 HIGH VOLTAGE TRANSFORMER MOUNTING INSULATORS
SLOTTED REAR
MOUNTING INSULATORS
FRONT MOUNTING
NOTE: On some machines the mounting screw configuration may be
INSULATORS
different.
