Wireless-G Access Point

The Back Panel

The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.

port: the connection point on a computer or networking device used for plugging in cables or adapters

Figure 3-2: Back Panel

LAN Port

The Ethernet network port connects to an Ethernet network device, such as a switch or router.

Reset Button There are two ways to reset the Access Point's factory defaults. Either press the Reset button, for approximately ten seconds, or use the Administration - Factory Defaults screen of the Access Point's Web-based Utility.

IMPORTANT: Resetting the Access Point will erase all of your settings (including wireless security, IP address, and power output) and replace them with the factory defaults. Do not reset the Access Point if you want to retain these settings.

Power Port The Power port connects to the Access Point’s power adapter.

Chapter 3: Getting to Know the Wireless-G Access Point

7

The Back Panel

Page 14
Image 14
Linksys WAP54G manual Back Panel LAN Port