4-2 Operating System Installation
Copyright © 2004 by LSI Logic Corporation. All rights reserved.
Step5. Scroll down the list until the appropriate selection for your system
which contains the Embedded SATA Software RAID and for your
operating system displays, then click <OK>.
Step6. Continue with the normal installation procedure.
4.1.1 Updating the Windows 2000/2003/XP Driver
Perform the following steps to update the Windows 2000 or 2003 driver or
install the Windows 2000 or 2003 driver into an existing system booted from a
standard IDE drive.
Step1. Click the Windows Start button.
The Windows menu displays.
Step2. Select Settings.
The Settings menu displays to the right.
Step3. Click Control Panel.
The Control Panel window displays.
Step4. Select Adapters.
Step5. Select the Drivers tab.
Step6. Scroll down the list until the appropriate selection for your system
which contains the Embedded SATA Software RAID and for your
operating system displays, then click <OK>.
Step7. Select it, then remove it by clicking the Remove button.
Step8. Click the Add button.
Step9. Select the Have Disk button.
Step10. Insert the diskette into the floppy drive.
Step11. Select drive letter A: and click on <OK>.
Step12. Select LSI Logic Embedded SATA Controller and click OK.
Step13. After Windows NT or Windows 2000 copies the driver, reset the
system.
4.1.2 Confirming the Windows 2000/2003/XP Driver Installation
Perform the following steps to confirm that the Windows 2000, 2003, or XP
driver is installed properly.