Chapter 3 Removal and Replacement Procedures
3-259
RRP12.3 CONTROLLER BOARD (PL12.1.4)(TBD)Figure: CONTROLLER BOARD Removal
Removal
1) Remove the COVER CASSETTE REAR. (RRP3.2)
2) From the rear side of the printer, loosen the screws that secure the CONTROLLER BOARD.
3) Holding the left and right knobs on the CONTROLLER BOARD, pull out the CONTROLLER BOARD of
the printer.
Replacement
Replace the components in the reverse order of removal.
In replacing the CONTROLLER BOARD on the printer, connect the connector at the
leading end of CONTROLLER BOARD to the connector of the PWBA HNB MCU
(PL12.1.1).