Chapter 8 Printer Specifications
8-409
4.10 Warm-up Time
When nominal voltage (100V, 115V, 220V) is applied, ready temperature ( Fuser Stand-by) is reached
within 30 seconds after command is given by the controller.
Reference: Measured at 72°F(22°C), 55% RH, nominal voltage.
4.11 FPOT (First Print Output Time)
FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the STA RT command is given is
calculated on the following conditions (rounded to one decimal place).
• IOT performance that the controller does not have IOT wait.
• Theoretical value with the ROS motor ON, Fuser Stand-by.
• A4 SEF paper
• When process control is acting, excluding *2 in the event of *1/Fuser Cool Down .
• Plain paper mode
• Paper sent from the 1st tray and MGI.
*1: Process control means TC control, potential control, cleaning cycle, REGI control and
that the engine stops paper feeding for a certain time during the continuous printing
operation.
*2: The print may not start for a certain time after receiving the start command due to prior
job running conditions.
4.12 Continuous Printing Speed
Assuming the time until the trailing end of the 11th sheet is discharged after the trail end of the 1st sheet is
discharged as t seconds, number of printed sheets for a minute given by the equation [60/t ×10] is shown in
the table below, excluding, however, the time for which the process control is working*1 and during the
Fuse Cool Down* 2 are not contained.
Paper mode
Resolution/Speed mode
600dpi 1200dpi
Print
mode Simplex Duplex Simplex Duplex
Plain paper
(1) to (4)
Standard Full speed Full speed – –
Fine – – Half speed Half speed
High Gloss Half speed Half speed – –
Special paper
(5) to (11)
Standard Half speed – – –
Fine – – Half speed –
Speed mode
FPOT(sec)
In Simplex mode
FPOT tS(sec)
In Duplex mode
FPOT td(sec)
Full speed ≤ 9.5 ≤ 18.0
Half speed ≤ 19.0 ≤ 34.0