Part identification and functions
11.SCSI connector: Connect the SCSI cable included in the interface kit. When multiple SCSI devices are connected to the personal computer, connect the Scanner at the end of the SCSI chain. (Optional PC interface kit is required)
The total length of the SCSI cables must be 6 m or less when used for
12.Foot switch connector: Connect the foot switch (option) cable to this connector. Use the left terminal (viewed from the rear) to read the right page when the foot switch is pressed, and the right terminal for the left page. Either terminal can be used when reading two spread pages.
13.Power cord socket: Plug the power cord into this socket.
14. Power cord: | Connects the Scanner to the power outlet. |
15.Foot switch (option): Press this switch instead of the start key on the book table to start scanning. Used when a large original is covering the start key.
16. Counter: | Counts the number of originals scanned. |
17.Angle book holder (option): Used to scan the original whose spine (binding part) should not be damaged (e.g., precious book).
18. | Stopper: | Used as the reference position for the original. When |
|
| placing the original, align its top edge with this position. |
19. | Center mark: | Adjust the center of the original to this mark. |
20. | Size guide: | Indicates the scannable range of the original. |
Overview Chapter 2
