
7521Plus / N N/B MAINTENANCE
8.12 PIO PORT TEST ERROR
When a print command is issued, printer prints nothing or garbage.
PIO TEST ERROR
1.Check the PIO device is installed properly.(J505)
2.Confirm CMOS LPT port and extended mode setting properly.
Troubleshooting for
PIO test error.
YES
Test
OK?
NO
Try another known good PIO device. (Such as printer)
YES
OK?
NO
Replace M/B or go
into
Correct
it and end.
Change the faulty device then end.
Check the following parts for cold solder or one of the following parts on the
Parts: | Signals: |
|
J505, C5 | P_STB# | P_D/PE |
U27, L1 | P_D/AFD# | P_D/SLCT |
FA1, FA2 | P_D/ERR# |
|
FA3, FA4 | P_LPD[0:7] |
|
FA5, | P_D/INIT# |
|
CA3~CA6 | P_D/SLIN# |
|
| P_D/ACK# |
|
| P_D/BUSY |
|