S Y M B O L S E T S / C O D E P A G E S

C

This appendix contains a listing of the symbol sets, code pages, and extended character sets the printers support.

Refer to your 9403 Operator’s Handbook or Keypad Operating Instructions to enter International and punctuation characters.

Use the charts in this appendix to convert dot sequences from the image dot pattern to codes you can use in the fields. Use the Binary to Hex Conversion Chart to convert Binary dot sequences to Hexadecimal numbers for bitmap files. Use the Dot to Run Length Encoding Chart to convert dot sequences to alphabetic characters for bitmap files.

S u p p o r t e d S y m b o l S e t s a n d C o d e P a g e s

The printers support these symbol sets and code pages: Internal, ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850. Additional Code Pages are supported with downloaded TrueType fonts.

The printer defaults to the internal symbol set. See "Defining the System Setup Packet" in Chapter 2 to change the symbol set.

S e l e c t i n g t h e I n t e r n a l S y m b o l S e t

Use this symbol set when you want to: use the international monetary symbols, create formats that may be used on other MPCLII printers, print the trademark () symbol.

The CG Triumvirate fonts and Font 50 support only the ANSI and DOS Code Page 437 and 850 Symbol Sets. These fonts print a slashed zero when using the ANSI symbol set. However, the scalable font does not print a slashed zero.

Symbol Sets/Code Pages C-1

Page 239
Image 239
Monarch 9830 P p o r t e d S y m b o l S e t s a n d code P a g e s, L e c t i n g t h e I n t e r n a l S y m b o l S e t