Multi-Tech Systems MMV1600 owner manual Command Summary, ATC1B4800P1F1E0, Type Command Description

5.1 Introduction

This chapter presents a command summary followed by a detailed description of each command used in the MultiMux. Each command line must begin with a prefix of AT and may contain any number of commands in a string (no spaces) up to a limit of 40 characters. Most commands include a value and are part of the 40 character total. Hitting Return executes a command line but does not incorporate it into the operation of your MultiMux. You must execute a Store New Parameters command (&W) to implement your changes into your mux network.

An example of a command line which changes the parameters of the channel device connected to channel 1is shown in the following example. The example changes the baud rate to 4800 bps, parity to odd, CTS flow control and turns echo off

ATC1B4800P1F1E0

Table 5-1 presents a summary of all the commands used in the MultiMux. The commands are divided into a number of general categories according to their functionality within the MultiMux. This functional division is carried on into the detailed description of each command.

The access commands for the command modem are described in this chapter. The general AT commands for the command modem are described in Appendix D.

The following functional grouping of the commands are listed with their paragraph title and paragraph number:

General Commands	5.2.1
Channel Parameter Commands	5.2.2
Composite Link Speed & Clocking commands	5.2.3
Additional Composite Link Commands	5.2.4
Voice/Fax Channel Commands	5.2.5
Test Commands	5.2.6
Command Modem Commands	5.2.7

		Table 5-1. Command Summary
TYPE	COMMAND	DESCRIPTION
General	H	General Help
	H1	Channel Parameter Help
	H2	DIP-Switch Configuration Help
	H3	Composite Link Speed and Clocking Help
	H4	Additional Composite Link Help
	H5	Miscellaneous Help
	H6	Voice/Fax Channel Help
	H7	Additional Voice/Fax Channel Help
	Z	Reset
	&W	Store New Parameters to Memory
Channel	B0	Channel Off Command
Parameter	Bxxx	Baud Rate Select
	C0	Universal Channel Parameters Command
	C1-C32	Channel Select for Parameter Change
	DC	Destination Channel Selection
	DN	Destination Node Selection
	E0	Echo Off
	E1	Echo On
	F0	Flow Control Off
	F1	CTS (RS232C) Flow Control
	F2	Xon/Xoff Flow Control
	F3	Enq/Ack On
	F4	EnqAck Off
	F5	Pacing On
	F6	Pacing Off
	F7	Pass EIA (RS232C) Signals On
	F8	Pass EIA (RS232C) Signals Off
	F9	Xon Pass Thru On
	F10	Xon Pass Thru Off
	F11	Inverter DTR On
	F12	Inverter DTR Off
	F13	Xoff/First Character Pacing