Table 6-2. Command Modem Operating Procedures (Cont.)
StepProcedure
4You are now communicating with your remote MultiMux. Any commands you now execute will be done by the remote unit. For instance, to request status of the remote system execute the List Channel Parameters Command by entering the following:
|
|
|
|
| ATL (hit Return) |
|
|
|
|
|
|
|
| |
The following, which will be an actual listing of the remote unit’s channel | parameters, will appear on your | |||||||||||||
|
|
|
| supervisory console: |
|
|
|
|
|
|
| |||
|
|
|
|
|
| Local Channel Parameters/ Node # 01 |
|
|
| |||||
|
|
|
| STP | FLOW | ENQ/ |
|
| PASS PASS DEST DEST LINK | |||||
CHN | SPD WD BIT PAR | CTRL | ACK ECHO PACE | EIA | XON | CHN NODE A/B | ||||||||
| 01 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 01 | 02 | A |
02 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 02 | 02 | A | |
03 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 03 | 02 | A | |
04 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 04 | 02 | A | |
05 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 05 | 02 | A | |
06 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 06 | 02 | A | |
07 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 07 | 02 | A | |
08 | 19200 | 8 | 1 | NONE | XON/XOFF | OFF | OFF | OFF | OFF | OFF | 08 | 02 | A | |
OK |
|
|
|
|
|
|
|
|
|
|
|
|
| |
To end your call to the remote site you can either terminate the whole |
| command modem operation and put | ||||||||||||
|
|
|
| your supervisory console back into | communications with your local MultiMux, or you can end the | |||||||||
|
|
|
| current call and remain connected to your command modem for additional remote communications. | ||||||||||
To end the current call and place supervisory console control back to the local MultiMux, enter the following command: AT#MA0 (hit Return)
To end the call and remain connected to your command modem, enter the following command:
+++ (hit Return)
Wait for the OK (0) Result code to be displayed on your supervisory console, then enter the following: ATZ (hit Return)
