
2.7 Configuration 6
Configuration 6 is the data/voice/fax configuration with two MultiMux MMV1608C/56/V multiplexers with single composite link connecting a minicomputer and a telephone and/or fax machine at the local site to a group of remote terminals and printer on the data part of the network and a second set of telephone and/or fax machine on the voice/fax channels. The FXS to FXS configuration is shown in Figure 
This configuration has the MV2 Voice/Fax board installed in the MMV1608/56/V multiplexers for the voice over data communications. Both sites have the MV2 Voice/Fax boards connecting VOICE/FAX CHANNEL 1and/or 2 FXS connector(s) on the back panel of the multiplexer to either a telephone and/or a fax machine or both.
Terminal
Terminal  | Printer  | Asynchronous  | 
  | 
  | Asynchronous  | |
Channel  | 
  | 
  | ||||
  | 
  | 
  | ||||
  | 
  | 
  | PDN  | 
  | Channel  | |
  | Modem  | 
  | 
  | 
  | 
  | |
  | 
  | 
  | Composite Link  | MultiMux 16  | 
  | |
  | 
  | MultiMux 16  | 
  | 
  | ||
Terminal  | 
  | 
  | 
  | Multiplexer | 
  | |
  | 
  | Multiplexer  | 
  | Minicomputer  | ||
  | PC  | 
  | Voice/Fax  | |||
  | 
  | 
  | ||||
Voice/Fax  | Voice/Fax Channel 2 FXS  | Channel 1  | Voice/Fax  | |||
FXS  | ||||||
Channel 1  | 
  | 
  | Channel 2 FXS  | |||
  | 
  | 
  | ||||
FXS  | 
  | 
  | 
  | 
  | 
  | |
  | 
  | 
  | 
  | Telephone  | 
  | |
  | Telephone  | Fax  | 
  | Local Site  | 
  | |
  | Remote Site | 
  | Fax  | |||
  | 
  | 
  | ||||
  | 
  | (Node 1)  | 
  | |||
(Node 2)
Figure 2-6.  Configuration 6 (FXS to FXS)
Both sites are configured for an FXS configuration on voice/fax channel 1and/or 2 using the V1LIFXS command and/or V2LIFXS command and setting the Remote Interface type for the same thing using the V1RIFXS and/or V2RIFXS. The parameters for local voice/fax channels can be displayed using the VL (List the voice/fax channel parameters) command. The voice/fax channel parameters are shown in Configuration 6 Voice/Fax Channel Parameters. The voice/fax channel parameters are described in Chapter 5 Commands of this manual.
LOCAL VOICE/FAX PARAMETERS CHANNEL1  | LOCAL VOICE/FAX PARAMTERS CHANNEL 2  | ||
PARAMETER  | STATUS  | PARAMETER  | STATUS  | 
DESTINATION CHANNEL:  | 01  | DESTINATION CHANNEL:  | 02  | 
DESTINATION NODE:  | 02  | DESTINATION NODE:  | 02  | 
LINK A/B/D:  | A  | LINK A/B/D:  | A  | 
DIGITIZING RATE:  | 16000  | DIGITIZING RATE:  | 16000  | 
OUTPUT LEVEL ATTEN.:  | 12  | OUTPUT LEVEL ATTEN.:  | 12  | 
INPUT LEVEL GAIN:  | 03  | INPUT LEVEL GAIN:  | 03  | 
SILENCE SUPPRESSION:  | 00  | SILENCE SUPPRESSION:  | 00  | 
LOCAL INTERFACE TYPE:  | FXS  | LOCAL INTERFACE TYPE:  | FXS  | 
GROUND/LOOP START (FXS):  | LOOP  | GROUND/LOOP START (FXS):  | LOOP  | 
2 OR 4 WIRE (E&M):  | 2 WIRE  | 2 OR 4 WIRE (E&M):  | 2 WIRE  | 
DIALTONE/WINK (E&M):  | N/A  | DIALTONE/WINK (E&M):  | N/A  | 
WINK TIMER (E&M)  | N/A  | WINK TIMER (E&M)  | N/A  | 
REMOTE INTERFACE TYPE:  | FXS  | REMOTE INTERFACE TYPE:  | FXS  | 
GROUND/LOOP START (FXS):  | LOOP  | GROUND/LOOP START (FXS):  | LOOP  | 
2 OR 4 WIRE (E&M):  | 2 WIRE  | 2 OR 4 WIRE (E&M):  | 2 WIRE  | 
DIALTONE/WINK (E&M):  | N/A  | DIALTONE/WINK (E&M):  | N/A  |