DCA-600SSK — OUTPUT TERMINAL PANEL CONNECTIONS
UVWO Terminal Output Voltages
Various output voltages can be obtained using the UVWO output terminal lugs. The voltages at the terminals are de- pendent on the placement of the jumpers plates (6) on the Voltage
Remember the voltage
3Ø-240V UVWO Terminal Output Voltages
1.Jumper the voltage
Figure 21. Voltage Change-Over Board
240V Configuration
2.Connect the load wires to the UVWO terminals as shown in Figure 22.
Figure 22. UVWO Terminal Lugs
3.Turn the voltage regulator knob (Figure 23) clockwise to increase voltage output, turn counterclockwise to decrease voltage output. Use voltage regulator adjustment knob whenever fine tuning of the output voltage is required
Figure 23. Voltage Regulator Knob
1Ø-240V UVWO Terminal Output Voltages
1.Make sure the voltage
2.Connect the load wires to the UVWO terminals as shown in Figure 24.
Figure 24. UVWO Terminal Lugs
1Ø-139V UVWO Terminal Output Voltages
1.Make sure the voltage
2.Connect the load wires to the UVWO terminals as shown in Figure 25.
Figure 25. UVWO Terminal Lugs
PAGE 38 —