DCA-600SSK — GENERATOR START-UP PROCEDURE (MANUAL)
BEFORE STARTING | 22. Place the engine speed switch in the “LOW ” position |
Generator and Control Panel | (Figure 62). |
|
CAUTION:
NEVER! manually start the engine with the main, GFCI or auxiliary circuit breakers in the ON (closed) position.
Steps 20 thru 26 are referenced for Engine Operating Panel
NOTES/N 3698617~. See Figure 59 below. This unit does not have
an ignition switch or a throttle handle. It does have an “engine speed switch” that is used in conjunction with the MPEC unit.
Figure 59. Engine Operating Panel
S/N 3698617~
Figure 62. Engine Speed Switch (Low)
23.Place the
Figure 63.
24.Once the engine is warm and the engine is running properly, place the engine speed switch in the “HIGH ” position (Figure 64).
Figure 64. Engine Speed Switch (High)
20.Set the battery ON/OFF switch (Figure 60) to the “ON” position.
Figure 60. Battery ON/OFF Switch
21.Press and hold the engine preheat button (Figure 59) until the preheat lamp is lit (ON).
Button | Lamp |
25.Verify that the "Engine Running" status LED on the MPEC unit (Figure 65) is "ON" (lit) after the engine has been started.
Figure 65. Engine Running LED (ON)
26.Continue operating the generator as outlined in steps 11 thru 19 (pages
Figure 60.
PAGE 48 —