700 Series Managed Switch User’s Guide for Software v2.1

IP-filter address

The IP-filter address allows you to enter and remove IP address from the approved list. Use the No command to remove an IP address.

Syntax

FSM726(config)# system ip-filter address <IP-address>

Where

<IP address> = an IP address that is authorized to access the management.

IP-Mode

The IP-Modecommand sets the IP assignment mode of the switch. There are three modes available to the user.

Manual – The user manually enter IP related information

BootP – Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from a BootP server on the network

DHCP – The switch accepts DHCP broadcast from a DHCP server and automatically configure IP related information

Syntax

FSM726(config)# system ip-mode [manual bootp DHCP]

Mask

Use the Mask command to set the network mask.

Syntax

FSM726(config)# system mask <network mask>

Where

<network mask> = network mask of your network

Gateway

Use the Gateway command to set the default gateway

Command Line Interface

6-27

SM-10004-02

Page 117
Image 117
NETGEAR 700 Series manual IP-filter address, IP-Mode, Mask, Gateway