NETGEAR 700 Series manual Set-up Port Configuration

700 Series Managed Switch User’s Guide for Software v2.1

Click Apply to change the IP settings

Save Configuration to NVRAM and reset the system to implement the changes (Tools > Save Configuration).

Set-up> Port Configuration

Figure 5-14: Port Configuration

This menu allows you can configure the status of each port.

•	Port:	The port number on the switch
•	Name:	The name of the port. This is a user-defined label.
•	Link:	A green triangle pointing up indicates a valid link, while a red triangle
		pointing down indicates no link.
•	On/Off:	Indicates if the port is enabled or disabled by the Administrator.
•	State:	This refers to the Spanning Tree state of the port. Ports will be Blocking
		(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled
		(Dis).
•	Speed:	Indicates the speed and duplex for the port. The possible entries are
		Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full
		duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full
		duplex (100M Full).

5-14 Web-Based Management Interface

SM-10004-02