NETGEAR 700 Series manual Set-up IP Configuration

700 Series Managed Switch User’s Guide for Software v2.1

This page will allow access to the system information parameters. To do so:

1.Enter System Name, System Contact, or System Location.

2.Click Apply to change the System Configuration and save it in NVRAM.

3.Reset the system to implement the changes (> Save Configuration).

Set-up> IP Configuration

Figure 5-13: IP Configuration

This menu manages the IP related information of the system.

IP Assignment Mode

•Manual – The user manually enters IP related information

•BootP – Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from a BootP server on the network

•DHCP – The switch accepts DHCP broadcast from a DHCP server and automatically configures IP related information

Note: In DHCP mode, if the switch fails to get a DHCP assignment, the switch defaults to 192.168.0.1 as its IP address.

To enable quick and easy set-up, the default setting is DHCP. However, DHCP addresses change over time, and you need to know the IP address of your switch so that you can remotely manage it. After completing the initial setup, change the IP assignment mode from DHCP to manual.

If you choose Manual mode, enter site-specific IP address, Gateway address and Net mask.

Web-Based Management Interface 5-13

SM-10004-02