700 Series Managed Switch User’s Guide for Software v2.1

Name

Use the name command to give a name to the switch. This is done to make the switch easier to identify.

Syntax

FSM726(config)# snmp-server name <switch name>

Where

<switch name> = the name you wish to give to the switch

Host

The host command is used to specify hosts to receive SNMP notifications.

Syntax

FSM726(config)# snmp-server host <host name> <host IP address> <community string>

Where

<host name> = the name of the host that is to receive SNMP notifications. <host IP address> = The IP address of the host specified <community string> = the community which the host belongs to

Host Authorization

The host-authorizationcommand enables SNMP host authorization.

Syntax

FSM726(config)# snmp-server host-authorization

Trap

The trap command enables SNMP trap. s IP is not in the SNMP host table.

Syntax

FSM726(config)# snmp-server trap

Command Line Interface

6-23

SM-10004-02

Page 113
Image 113
NETGEAR 700 Series manual Name, Host Authorization, Trap