700 Series Managed Switch User’s Guide for Software v2.1

FSM726(config)# diffserv <DSCP> <priority>

Where

<DSCP> = The DSCP value, which ranges from 0-63

<Priority> = The priority associated with the defined DSCP value. The available options are normal and high

For example, suppose you want to set DSCP 33 to high, the command to do so would be:

FSM726(config)# diffserv 33 high

Exit

The exit command takes you out of the CLI mode by one level. For example, when you are in configuration mode, and the prompt looks like FSM726(config)#. By entering exit at the prompt, you will exit the configuration mode and be taken back to the root level, where the prompt looks like FSM726#. When you enter the exit command at the root level, you will return to the Main Menu of the switch.

Syntax

FSM726(config)# exit

Interface

The interface command allows you to configure each network interface of the switch. Items such as the speed, duplex, and negotiation are configured in this mode. The command to enter the interface mode is

Syntax

FSM726(config)# interface ethernet <x/y>

Where

<x/y> = x is the stack number, and y is the port number, which ranges from 1-26. Since FSM726 is not stackable, the value of x is always 1.

For example, suppose you want to configure port 8 on the switch, the command to do so would be:

FSM726(config)# interface ethernet 1/8

Command Line Interface

6-13

SM-10004-02

Page 103
Image 103
NETGEAR 700 Series manual Exit, Interface