NETGEAR 700 Series manual Switchport

700 Series Managed Switch User’s Guide for Software v2.1

Switchport

The switchport command lets you configure VLAN access mode of this particular port.

•VLAN syntax

FSM726(config-if)# switchport access vlan [tagged <VLAN Membership> untagged <VLAN membership>]

Where:

tagged <VLAN Membership> = setting the VLAN membership to tagged mode. VLAN Membership ranges from 1-4094

untagged <VLAN Membership> = setting the VLAN membership to untagged mode. VLAN Membership ranges from 1-4094

For example, suppose this particular port belongs in VLAN 64 and 32. You wish to configure it so that it operates in tagged mode in VLAN 64, but in untagged mode in VLAN 32, the command to do so would be:

FSM726(config-if)# switchport access vlan tagged 64

FSM726(config-if)# swtichport access vlan untagged 32

•Native

All untagged packets entering the switch will by default be tagged with the ID specified by the port’s PVID. This command allows you to specify the PVID for each port. The PVID values ranges from 1-4094. Following industry standards, PVID 1 is the default PVID

Syntax

FSM726(config-if)# switchport access native <PVID value>

where

<PVID Value> = the PVID value assigned for this particular port.

6-18 Command Line Interface

SM-10004-02