NETGEAR 700 Series manual Firmware TFTP-IP, Firmware TFTP-File

700 Series Managed Switch User’s Guide for Software v2.1

Warning: The previous image in non-volatile memory will be lost when the procedure completes.

•Last Saved option

The system will boot from non-volatile memory. This option will automatically show up after the ‘Net & save’ option is selected and the unit is reset.

Syntax

FSM726(config)# system firmware boot [net-tftp net-and-save last saved]

Firmware TFTP-IP

The Firmware TFTP-IPcommand is used to specify the IP location of the TFTP server where the new software image is stored.

Syntax

FSM726(config)# System firmware tftp-ip <IP address>

Where

<IP address> = the IP address of the TFTP server where the new firmware image is stored.

Firmware TFTP-File

The Firmware TFTP-Filecommand is used to specify the path and the filename of the new firmware image.

Syntax

FSM726(config)# System firmware tftp-file <path&filename>

Where

<path&filename> = the path and the filename of the new firmware image

RADIUS

For enhanced security, you can choose to have authentication done through the RADIUS server if one is present on your network.

•Authen-Mode

The authen-modecommand configures the method in which the user is authenticated.

6-30 Command Line Interface

SM-10004-02