Power source
1.Always use the power source of 100 - 240 V, 50 - 60 Hz.
Use the power cord subject to the voltage of power source, and if you use over AC125 V:
•the plug must be rated for AC250 V 15 A
•the insulation of the cord must be more than SVT type, and be a suitable cord of at least AWG18 and approved under safety regulations of the nations in which it is used .
2.Once the power source is turned off, do not turn it on until at least 5 minutes have passed .
3.Don 'tunplug the unit while the power is on .
4.Don 't hold the cord itself when unplugging the unit.
5.The power source must be grounded . A jOint ground with other instruments is indispensable, or else a ground loop, which can cause electrical shocks and electrical noise, may result.
6.Don 'tunplug the peripherals while the power is on .
7.Don 't carry the main unit while the power is on.
•Be sure to use the unit in a horizontal orientation only; a perpendicular orientation will cause misoperation .
•Don 't use a slide mount more than 3 mm thick. If the slide mount is not flat on its surface, you may feel some roughness when mounting or unmounting the slide.
•Don 't force the
•When moving the scanning stage, don 't touch or unmount the strip film holder.
•Don 't disassemble the main unit. It is dangerous to touch the internal components because of
•Don 'tput the things inside the unit. Flammable materials, metals, water etc., will cause fire, electrical shock, damage and misoperation .
In emergency
If you find something unusual, such as abnormal noise, smells or smoke, turn off the power switch, and take the unit to the dealer from whom you purchased it.
8
