Nikon LS-10E instruction manual Scanner side mounting holes

[b)[a]

	[e)
[c)	[d)	[I]
Fig. 3.4	A typical computer drive bay slot
	(The drive bay as seen from the front)

Emplacement typique 5 1/4" demi hauteur, vu de I'avant

Eln typlscher Computer·Schachteinschub (Vorderansicht des Laufwerkschachts)

The scanner will slide into a 5 1/4" half-height drive bay as shown in Figure 3.4. Since you will be inserting film into the scanner, the computer must have a cutout for this drive bay. In other words, the drive bay must be externally accessible. The scanner will be powered from the computer using the standard computer drive power supply connector. The computer motherboard needs to have an available single short connector slot for the SCSI interface board .

[a]Rai I slots

[b)Rail stop screws

[c)Rail stop (open)

[d)Drive slot

[e)Insert LS-10 here

[I]Rail stop (closed)

The computer drive bay has one or two metal stops screwed into the tapped holes on the sides of each half- height drive slot as shown in Figure 3.4. These should be loosened to allow them to either be removed or hung freely so they do not block the drive bay receptacles for the guide rails . These will be repositioned after the scanner is installed to lock the scanner in place.

The scanner side mounting holes

Two sets of vertical holes are provided on the sides of the scanner. These are called the top and bottom rail mounting holes. One set must be chosen in accordance with where the computer allows the scanner to be positioned in the drive bay. Most computers require that the bottom set of mounting holes be used. Position the rails at the bottom of the scanner and, while holding the scanner, see if the scanner will slide into the bay rail slots.

32