Nortel Networks 400-S manual Chapter Introduction, Instant Internet package

25

Chapter 1

Introduction

This chapter introduces your Instant Internet 400-S unit and describes package contents, available options for your Instant Internet unit, and any requirements and compatibility issues.

Caution: Before you install your unit, make sure that the power voltage selector switch setting matches your power voltage. For details, refer to “Setting the voltage selector switch” on page 42.

Instant Internet package

The Instant Internet package contains:

•Instant Internet 400-S unit

•Depending on the type of connection you ordered, your Instant Internet package contains one or more of the following connector cables:

—RJ-11 cable (phone cord) for a dial-up connection or 1-Meg modem connection

—ISDN cable for an Integrated Service Digital Network (ISDN) connection

—Two RJ-45 cables for a 10BASE-T or 100BASE-T Ethernet connection

—Two RJ-45 crossover cables for a 10BASE-T or 100BASE-T Ethernet connection

—RJ-48 cable for a T1 connection or an E1 connection

Note: If you ordered your Instant Internet unit for use with a V.35 or X.21 modem, you must provide the connection cable. For pinout diagrams for V.35 and X.21 adapter cables, refer to Appendix B, “Adapter cable pinout diagrams,” on page 77.

Setting Up the BayStack Instant Internet 400-S Unit