Nortel Networks 400-S manual Command prompt

Chapter 7 Out-of-band management support 69

6From the Bits per second list, select 115200 to set the modem speed, and then click OK.

HyperTerminal establishes a connection to the Instant Internet unit. If the Instant Internet unit is password protected, the session begins by requesting a password. Enter the password for the Instant Internet unit and then press Enter.

Note: If you enter an incorrect password, the message “Incorrect Login” is displayed and you are prompted to enter a correct password. You are given two more chances before Instant Internet ends the session and disconnects you.

When you successfully log on, the command prompt is displayed (Figure 11) and you can begin using remote access commands to configure the unit.

Figure 11 Command prompt

BayStack Instant Internet(tm) version 7.11 Copyright (c) 1995-2000 Nortel Networks Corporation ii>

Configuring the Instant Internet unit through a dial-up connection

To configure the unit through a dial-up connection using the out-of-band management feature, you must:

•Connect the modem to a PC.

•Use a terminal emulation software application to configure the modem connection settings.

•Connect the modem to your Instant Internet unit.

Setting Up the BayStack Instant Internet 400-S Unit