Series Fiber MDAs | Nortel Networks 1000BASE-XD, 8100 specification

Media Dependent Adapters

Table C-3 shows the 8100-4TX MDA LEDs.

Table C-3.		8100-4TX MDA LEDs

Label	Type		Color/State	Meaning

100	100BASE-TX port status		Green/On	The corresponding port is set to operate at 100 Mb/s.
	LEDs		Green/Blinking	The corresponding port is management disabled.
			Green/Blinking	The corresponding port is management disabled.
			Off	The link connection is bad, or there is no connection
				to this port.

10	10BASE-T port status		Green/On	The corresponding port is set to operate at 10 Mb/s.
	LEDs		Green/Blinking	The corresponding port is management disabled.
			Green/Blinking	The corresponding port is management disabled.
			Off	The link connection is bad, or there is no connection
				to this port.

F Dx	Full-duplex port status		Green/On	The corresponding port is in full-duplex mode.
	LEDs		Off	The corresponding port is in half-duplex mode.
			Off	The corresponding port is in half-duplex mode.

Activity	Port activity LEDs		Green/Blinking	Indicates the network activity level for the
				corresponding port. A high level of network activity
				can cause LEDs to appear to be on continuously.

8100 Series Fiber MDAs

The 8100 Series fiber MDAs are used to make fiber-based 100 Mb/s connections to the switch. Two versions of these MDAs are available (Figure C-4):

•The 8100-2FX MDA uses two longwave 1300 nm SC connectors to connect devices over 62.5/125 µm multimode fiber optic cable.

•The 8100-4FX MDA uses four longwave 1300 nm MT-RJ connectors to connect devices over 62.5/125 µm multimode fiber optic cable.

The 8100 Series fiber MDAs are not supported on single-mode fiber cable.

204515-C

C-5

Image 87

Nortel Networks 1000BASE-XD manual Series Fiber MDAs, Table C-3 8100-4TX MDA LEDs

Contents

Using the Passport 8100 Modules EC Declaration of Conformity EN 55 022 Statement Bureau of Standards, Metrology and Inspection Bsmi Statement Voluntary Control Council for Interference Vcci Statement 204515-C 204515-C 204515-C Contents Chapter Installing a Passport 8100 Module Appendix a Technical Specifications Appendix C Media Dependent Adapters Figures Figure C-1 BASE-SX Shortwave Gigabit MDA Front Panels Tables Xiv Before You Begin Preface Italic text Text Conventions Related Publications Xviii Technical Solutions Center Telephone Number How to Get HelpPage Chapter About the Passport 8100 Modules Features About the Passport 8100 Modules Passport 8190SM Management Module Passport 8190SM Switch Management Module Ethernet Management Port Pcmcia Card Slot DTE/DCE SwitchReset Button Serial Ports LEDs on the Passport 8190SM Module LEDs Passport 8132TX 32-Port I/O Module 10BASE-T/100BASE-TX Port Connectors Comm Port MDA Slot LEDs on the Passport 8132TX Module Passport 8148TX 48-Port I/O Module Passport 8148TX Edge Switch Module LEDs on the Passport 8148TX Module Passport 8108GBIC 8-Port I/O Module Passport 8108GBIC Module Redundancy Features Redundant Passport 8190SM Modules Redundant Power Supplies Chassis Number Hot-Swap One? Modules Power Supplies Power Supply Hot-Swapping Combining Passport 8100 and Passport 8600 Modules Chapter Installing a Passport 8100 Module Safety and Environmental Precautions Chassis Configuration Requirements Removing a Filler Panel Installing a Module Slide the module into the slot Figure Securing the Module in the Chassis Turning On the Chassis Power Connecting Cables Routing Network Cables Replacing Modules To replace a module Chapter Basic Switch Configuration Port Numbers on High-Density Modules Specifying Port Numbers Booting the Switch Access Levels and Default Login Values Access Level Description Default Login PasswordLogging On to the System Assigning an IP Address to the Management Port Setting System Identification Change CLI users and passwords using the following commands Setting System Security Change Web passwords using the command To assign an IP address for management, use the command Switch Configuration Specify a default gateway address/default route Page Normal Power-Up Sequence Chapter Troubleshooting Failure to Get a Login Prompt from the Console Port LED Indications of ProblemsFailure of Management Software to Recognize I/O Modules Symptom Probable Cause Corrective Action LED Indications of Problems Cabling Port Connection Problems Autonegotiation Modes Port Interface Use the CLI to disable autonegotiation for the suspect port Addresses Installation-Related IssuesPage Appendix a Technical Specifications General SpecificationsStandards Supported Data Rate and Encoding Environmental SpecificationsPerformance Specifications 64-byte packets Safety Agency Approvals Passport 8190SM Switch Management Module Connector Pin Number Signal Management PortConsole Serial Port Table A-3 DTE-to-DCE Pin Assignments Modem Serial Port Passport 8132TX Module Data Port ConnectorsConnector Type Cable Specifications 450-1LR MDA, 450-1LX MDA Comm Port ConnectorMDAs 450-1SR MDA, 450-1SX MDA Port Connectors Passport 8148TX ModuleTable A-5. Passport 8148TX Port Pinouts GBICs Passport 8108GBIC Module 1000BASE-SX Gbic Optical Specifications 1000BASE-XD Gbic Figure A-1. MDI-X to MDI Cable Connections MDI and MDI-X Connections Figure A-2. MDI-X to MDI-X Cable Connections Declaration of ConformityPage Figure B-1. LEDs on the Passport 8190SM Module Appendix B LEDs Label Color/State Meaning Table B-1 LED Operation on the Passport 8190SM Module Figure B-2. LEDs on the Passport 8132TX and 8148TX Modules Passport 8132TX and 8148TX I/O Modules Color/State Meaning LED Table B-5 Port LEDs on the Passport 8108GBIC Module Page Appendix C Media Dependent Adapters Figure C-1 BASE-SX Shortwave Gigabit MDA Front Panels Series MDAs Label Type Color/State Meaning Table C-1 1000BASE-SX MDA LEDs Table C-2 1000BASE-LX MDA LEDs 8100-4TX MDA Table C-3 8100-4TX MDA LEDs Series Fiber MDAs Table C-4 Series MDA LEDs Figure C-4 Series MDA Front Panels Figure C-5. Installing an MDA Installing an MDA Using the Passport 8100 Modules Figure D-1. Types of GBICs Appendix D Installing GBICs Figure D-2. Installing a Gbic Installing a Gbic To remove an installed Gbic Page Appendix E RFCs and Standards Page Numbers Index Index-2 Index-3 Index-4