Olivetti 2701, 2301 operation manual Troubleshooting Related to Saddle Stitch Finisher, 79p

TROUBLESHOOTING (RELATED TO SADDLE STITCH FINISHER)

If you experience difficulty with the saddle stitch finisher, check the following troubleshooting guide before calling for service. Many problems can be resolved by the user.

Problem	Cause and solution	Page
	The staple function is not set correctly for the desired	7
Stapling position is not correct	staple position.
		(step 4)
	Check the possible staple positions and adjust appropriately.
	The top cover or front cover of the saddle stitch finisher
	is open.	1
The saddle stitch finisher does not	Close all covers.
	A message appears instructing you to remove paper from
operate
	the stapler compiler.
		9
	Remove all paper that remains in the stapler compiler as
	explained in step 4 on page 9.
	A message appears instructing you to check the staple
	unit.	9
	Remove the staple jam.
	A message appears informing you that staples are
	needed.	8
	Replace the staple cartridge. Make sure that the staple box
Stapling does not take place
	has been installed.
(including saddle stitch)
	Different widths of paper are mixed together.	-
	Stapling of different widths of paper is not possible.
	The paper is badly curled and is not stapled when output.
	Some qualities and types of paper result in bad curling when	-
	output. Remove the paper from the tray or the bypass tray,
	turn it around to reverse the top and bottom, and reload it.
Incorrect punch position*1	The punch function is not set for the desired punch
	position.	4
	Check the possible punch positions and adjust appropriately.
	A message appears instructing you to check the punch
	unit.	10
	Discard the punch waste.
	Different widths of paper are mixed together.	-
Punching does not take place*1	Punching of different widths of paper is not possible.
	The paper is badly curled and is not punched when
	output.
	Some qualities and types of paper result in bad curling when	-
	output. Remove the paper from the tray or the bypass tray,
	turn it around to reverse the top and bottom, and reload it.
	The cable between the machine and the saddle stitch
"CALL FOR SERVICE.	finisher is not connected.
	Turn off the power of the machine, connect the cable on the	-
CODE:F1-53." is displayed.
	back of the saddle stitch finisher to the connector on the
	machine, and then turn on the machine power.

*1 When an optional punch unit is installed.

79p