Olivetti 2301, 2701 operation manual Using the KEY Operator Programs, 79q

USING THE KEY OPERATOR PROGRAMS

When the saddle stitch finisher is installed on the multifunction machine, the key operator programs indicated below are added or changed. For information on "USING THE KEY OPERATOR PROGRAMS", see page 2 of the "Key operator's guide" that comes with the machine.

■Added programs

The following two programs are added to "DEVICE CONTROL" (page 12 of the "Key operator's guide"):

Disabling of finisher

This program is used to prohibit use of the saddle stitch finisher. The program is also used if the finisher fails. When use of the finisher is prohibited, the staple function, saddle stitch function, punch function, and output destination are grayed out.

Saddle stitch position adjust

This program is used to adjust the stapling position (folding position) when the saddle stitch function is used. The position can be shifted within a range of ±3.0 mm from the base position in increments of 0.1 mm. When "AUTOMATIC SADDLE STITCH" is disabled and "SADDLE STITCH" is selected in "OUTPUT", the display does not change to the pamphlet setting screen.

Max. +3 mm

Position when shifted to the "+" side

1

2

Max. -3 mm

Position when shifted to the "-" side

12

11

Base position

■Changed programs

The "OUTPUT TRAYS" and "INITIAL STATUS SETTINGS" programs are changed when the saddle stitch finisher is installed.

Output trays

A combination of output destinations can be selected for copying, printing, and fax in "OUTPUT TRAYS" in "DEVICE CONTROL". When the saddle stitch finisher is installed, the combinations that can be selected are as shown at right.

Selections	Description
PATTERN 1	Copying: Offset tray
	Printing: Center tray
	Fax: Center tray
PATTERN 2	Copying: Center tray
	Printing: Offset tray
	Fax: Center tray
PATTERN 3	Copying: Center tray
	Printing: Offset tray
	Fax: Offset tray
PATTERN 4	Copying: Offset tray
	Printing: Center tray
	Fax: Offset tray

If the machine does not have the fax function, Note "PATTERN 3" and "PATTERN 4" do not

appear and the tray positions in "PATTERN 1" and "PATTERN 2" change.

Initial status settings

The stapling position when the copy settings are returned to the default settings can be selected. Select the stapling position for the staple sort function in "OUTPUT" in "INITIAL STATUS SETTINGS" of the "COPY

FUNCTION SETTINGS".

79q