1-6 Configuring and Starting NetScan NetScan User’s Manual
If you ordered ChartView Plus, you must enter the registratio n ID number as it appears on your
ChartView Plus Registration Sheet. Otherwise, press Next and continue to follow the screen prompts.
Screen Prompt for Entering the ChartView Plus ID
Using the NetScan Configuration Utility
NetScan must be configured before you can use it in the ethernet mode. Configuration is accomplished
through the NetScan Configuration Utility that activates after you select “NetScan” as your device type.
The utility’s window displays a “welcome” prior to prompting you through the required configur ation steps.
The following steps appear in the utility’s screen prompts. Note that each “step” has a corresponding tab
(see following figure).
Note: The network interface must be properly configured before NetScan can communicate with a
computer via the ethernet. The NetScan Configuration Utility application completes this task by
sending configuration settings from your computer’s serial port to the configuration port (CONFIG)
on NetScan’s Ethernet Interface.
Step 1
Select an available serial communication port (COMM Port) from your computer.
Step 2
a) Disconnect the network cable (10Base-T type) from NetScan’s ETHERNET connector on the Ethernet
Interface portion of NetScan.
b) Cycle NetScan’s power switch “Off,” then “On.”
c) Check (3) the on-screen box that states, “I have performed the actions desribed above.”
Step 3
Basic information regarding TCP/IP Addressing begins on page 1-8. The section includes
definitions and describes four different operating scenarios.
If you have any difficulty regarding address settings, please contact your network
administrator.
a) If necessary, make changes to the address settings, then press the Apply Changes button. You may
need to refer to the TCP/IP info r mation beginning on page 1-8, or contact your ne twork administrator.
b) Press the Next button (see following figure).