NetScan User’s Manual ChartView Quick Start and Tutorial 2-9
ChartView Toolbar Reference
Configure channels and alarms as follows.
◊ (14) On ChartView’s Main Window, click on Setup in the pull-down menu row. The Setup pull-down
menu appears, allowing you to make more specific selections.
◊ (15) Click on the Channels & Alarms selection. The Channel and Alarm Setup dialog box appears, similar
to that shown in the following figure.
◊ (16) Enable the desired channels. You can enable channels by double-clicking on the applicable channel’s
“On” column, obtaining “On” indicating enabled or “Off” indicating disabled. You can also use a pull-
down list which appears for enable/disable. See Chapter 4 if more detail is needed.
Channels set up for your display will be automatically enabled. You can enable additional
channels for data acquisition. These additional channels will not appear on ChartView’s
Main Window, but data from them will still be acquired.
◊ (17) Click on the “Enable SpreadSheet Reading” button (see previous figure). This activates the display
scanned data in the reading column. Since we are in the Simulated Instrument mode, the Reading column
of the Analog Input SpreadSheet will now display simulated data. Selecting the Enable SpreadSheet
Reading button again will freeze the Reading column’s display.