Onkyo TX-SR876 instruction manual 103

Advanced Setup—Continued

5	Use the Down [w] button to select
	“Channel”, and then use the Left
	and Right [e]/[r] buttons to
	select a speaker.
	You can select: “Front”, “Center”,
	“Surround”, “SurrBack”, or “Sub-
	woofer”.
	2–5.	Equalizer Settings
	Equalizer		Manual
	Channel		Front
	63Hz		0dB
	160Hz		0dB
	400Hz		0dB
	1000Hz		0dB
	2500Hz		0dB
	6300Hz		0dB
	16000Hz		0dB
	MOVE	VALUE	RETURN RETURN SETUP EXIT
6	Use the Up and Down [q]/[w] but-
	tons to select a frequency, and
	then use the Left and Right
	[e]/[r] buttons to adjust the
	level at that frequency.
	You can select: “63Hz”, “160Hz”,
	“400Hz”, “1000Hz”, “2500Hz”,
	“6300Hz”, or “16000Hz”. And for the
	subwoofer, “25Hz”, “40Hz”, “63Hz”,
	“100Hz”, or “160Hz”.
	The volume at each frequency can be
	adjusted from –6 to +6 dB in 1 dB
	steps.
	Tip:
	Low frequencies (e.g., 160Hz) affect
	bass sounds; high frequencies (e.g.,
	6300Hz) affect treble sounds.
7	Use the Up and Down [q]/[w] but-
	tons to select “Channel”, and

then use the Left and Right

[e]/[r] buttons to select another speaker.

Repeat steps 6 and 7 for each speaker.

8	Press the [SETUP] button.
	The setup menu closes.

Notes:

•When the listening mode is set to Direct or Pure Audio, no effect will be produced.

•The Equalizer settings have no effect on 176.4/ 192 kHz input signals.

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

103