Onkyo TX-SR876 instruction manual 129

NET/USB (TX-NR906only)—Continued

3	Use the Up and Down [q]/[w] but-
	tons to select “6. Network”, and
	then press [ENTER].
	The “Network” screen appears.
	7-6. Network
	MAC Address	xx : xx : xx : xx : xx : xx
	Control	Enable
	Port	xxxxx

MOVE VALUE ENTER INPUT RETURN RETURN SETUP EXIT

4	Use the Up and Down [q]/[w] but-
	tons to select the settings, and
	use the Left and Right [e]/[r]
	buttons to set them.
	To enter an IP address, select the set-
	ting, and then press [ENTER]. The
	arrow [q]/[w]/[e]/[r] buttons can
	then be used to enter numbers. Press
	[ENTER] again to set the number.
	The settings are explained on the next
	page.
5	When you’ve finished, press the
	Up and Down [q]/[w] buttons to
	select “ Save Settings”, and
	then press [ENTER].
	Setup closes.
	7-6. Network
	Proxy	Disable
	Proxy URL
	Proxy Port	8080
	Save Settings
	MOVE VALUE	ENTER ENTER RETURN RETURN SETUP EXIT

When modifying network settings, after modifying it is necessary to exe- cute “ Save Settings”.

6	When you’ve finished, press the
	[SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Mac Address

This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.

Control

This setting enables or disables control over the network. Enable: Control over the network enabled.

Disable: Control over the network disabled.

■Port

This is the network port used for control over the net- work.

DHCP

This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.

Enable: DHCP enabled.

Disable: DHCP disabled.

If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.

IP Address

If you set the “DHCP” setting to “Disable”, you must specify an IP address. Enter a static IP address provided by your ISP.

The IP address must be within the following ranges. Class A: 10.0.0.0 to 10.255.255.255

Class B: 172.16.0.0 to 172.31.255.255

Class C: 192.168.0.0 to 192.168.255.255 Most routers use Class C IP addresses.

Subnet Mask

If you set the “DHCP” setting to “Disable”, you must specify a subnet mask address.

Enter the subnet mask address provided by your ISP (typically: 255.255.255.0).

Gateway

If you set the “DHCP” setting to “Disable”, you must specify a gateway address.

Enter the gateway address provided by your ISP.

DNS Server

If you set the “DHCP” setting to “Disable”, you must specify a DNS server.

Enter the DNS server addresses provided by your ISP.

Proxy URL

To use a Web proxy, enter its URL here.

Proxy Port

If you’re using a Web proxy, enter a proxy port number here.

129