Onkyo TX-SR876 instruction manual 100, Speaker Level Calibration

Advanced Setup—Continued

7 Use the Up and Down [q]/[w] but- tons to select a speaker, and use the Left and Right [e]/[r] but- tons to specify the distance. Specify the distance from the speaker to your listening position.

Notes:

• You can specify different distances for front Speakers A and front Speakers B, but not the other speak- ers (i.e., subwoofer, center, surround, and surround back).

• The “Center” distance cannot be set if the “Center” is set to “None” (page 95) or “Not Use” (page 98).

• The “SurrRight” and “SurrLeft” dis- tances cannot be set if the “Sur- round” is set to “None” (page 95) or “Not Use” (page 98).

• The “SurrBack R” and “SurrBack L” distances cannot be set if “Speaker Type: Front(Speaker A) or Front(Speaker B)” is set to “Bi-Amp” or “BTL” (page 61), “SurrBack” is set to “None” (page 95) or “Not Use” (page 98), or “Powered Zone2” is being used (page 132).

• The “Subwoofer” distance cannot be set if “Subwoofer” is set to “No” (page 96).

8	Repeat step 7 for each speaker.
9	Press the [SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 64).

With the “Level Calibration” settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listen- ing position. You can adjust the levels of front Speakers A and front Speakers B independently. The other speak- ers (i.e., subwoofer, center, surround, and surround back) use the same level settings for Speakers A and Speakers B.

Notes:

•The speakers cannot be calibrated while the output of the AV receiver is muted.

•The test tone is output at the standard level for THX, which is 0 dB (absolute volume setting 82). If you nor- mally listen at volume settings below this, be careful because the test tone will be much louder.

		REMOTE MODE
	DVD	VCR		CD				ZONE2
				CDR/MD/DOCK					1
	TV	CABLE		NET/USB				RECEIVER
		SAT						TAPE/AMP
3-6	DIMMER							SLEEP
			ENU	M	EN
		M				U
		OP
		T
	+
	CH		ENTER					VOL
	DISC
	ALBUM
2, 7	-	G
			UIDE	IT
	PREV			EX
		S					N
	CH	ETUP		RETU
	DISPLAY							MUTING
	REC		PLAYLIST					RANDOM
		SP A			SP B				1*
		LISTENING MODE
	STEREO	SURR
	REPEAT	AUDIO		SUBTITLE				PLAY MODE
	PURE A	DIRECT		THX				ALL ST
								*TX-NR906 only

1	Press the [RECEIVER] REMOTE
	MODE button, and then use the
	remote controller’s [SP A] or
	[SP B] button to select Speakers
	A or Speakers B, respectively
	(TX-NR906 only).

Notes:

•Speakers B cannot be selected if “Speaker Type: Front(Speaker B)” is set to “Not Use”.

•TX-SR876 continue with step 2 after press the [RECEIVER] REMOTE MODE button.

2	Press the [SETUP] button.
	The main menu appears onscreen.

100