Advanced Setup—Continued

3

4

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER].

The “Speaker Setup” menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

MOVE

ENTER

ENTER

RETURN

RETURN

SETUP

EXIT

Use the Up and Down [q]/[w] but- tons to select “4. Level Calibra- tion”, and then press [ENTER].

The “Level Calibration” screen appears and the pink noise test tone is output by the front left speaker.

2–4.

Level Calibration

 

Left

-12.0dB

 

Center

-12.0dB

Speaker A

Right

-12.0dB

 

SurrRight

-12.0dB

 

SurrBack R

-12.0dB

 

SurrBack L

-12.0dB

 

SurrLeft

-12.0dB

 

Subwoofer

-15.0dB

 

MOVE

VALUE

RETURN RETURN SETUP EXIT

Note:

Levels cannot be adjusted for speakers set to “No” or “None” in the Speaker Configuration (page 95).

5 Use the Up and Down [q]/[w] but- tons to select a speaker, and use the Left and Right [e]/[r] but- tons to adjust the level.

Levels can be adjusted from –12 to +12 dB in 0.5 dB steps (–15 to +12 dB for the subwoofer).

Notes:

• You can set different levels for front Speakers A and front Speakers B, but not the other speakers (i.e., sub- woofer, center, surround, and surr back).

• The “Center” level cannot be set if the “Center” is set to “None” (page 95) or “Not Use” (page 98).

• The “SurrRight” and “SurrLeft” lev- els cannot be set if the “Surround” is set to “None” (page 95) or “Not Use” (page 98).

• The “SurrBack R” and “SurrBack L” levels cannot be set if “Speaker Type: Front(Speaker A) or Front(Speaker B)” is set to “Bi-Amp” or “BTL” (page 61), “SurrBack” is set to “None” (page 95) or “Not Use” (page 98), or “Powered Zone2” is being used (page 132).

• The “Subwoofer” levels cannot be set if “Subwoofer” is set to “No” (page 96).

6

Repeat step 5 until the volume of

 

 

the test tone from each speaker

 

is the same.

 

If you’re using a handheld sound level

 

meter, adjust the level of each speaker

 

so that it reads 75 dB SPL at the listen-

 

ing position, measured with C-weight-

 

ing and slow reading.

 

 

7

Press the [SETUP] button.

Setup closes.

 

Notes:

Speaker levels can also be adjusted by using the dedi- cated buttons on the remote controller. Press the [TEST TONE] button to output the test tone. Use the [CH SEL] button to select each speaker, and use the [LEVEL–] and [LEVEL+] buttons to adjust the level.

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

101

Page 101
Image 101
Onkyo TX-SR876 instruction manual 101, Repeat until the volume, Test tone from each speaker, Is the same