Onkyo TX-SR876 Turn on the AV receiver, Connected TV, Place the speaker setup micro, Press Enter

First Time Setup—Continued

The onscreen menus shown in this manual may be slightly different from what you see on your TV.

1	Turn on the AV receiver and the
	connected TV.
	On the TV, select the input to which the
	AV receiver is connected.
2	Place the speaker setup micro-
	phone at measurement point 1
	(page 64), and connect it to the
	SETUP MIC jack.

Auto Speaker Setup

Next

1

Please place microphone at center of listening area at ear height.

ENTER ENTER

Notes:

•Before starting Audyssey MultEQ® XT Automatic Speaker Setup, arrange the room and connect the speakers as you would for enjoying movies. Changes to the room after auto setup requires you run the auto setup again, as room EQ characteristics may have changed.

•When starting the automatic speaker setup, do not stand between the speakers and microphone, and avoid obstacles blocking the path between speakers and microphone. This will produce inaccurate results.

•Position the microphone at ear height of a seated listener with the micro- phone tip pointed directly at the ceil- ing using a tripod. Do not hold the microphone in your hand during measurements as this will produce innacurate results.

•Make the room as quiet as possible. Background noise can disrupt the room measurements. Close win- dows, silence cell phones, televi- sions, radios, air conditioners, fluorescent lights, home appliances, light dimmers, or other devices.

•Cell phones should be turned off or placed away from all audio electron- ics during the measurement process as Radio Frequency Interference (RFI) may cause measurement dis- ruptions (even if the cell phone is not in use).

3

4

5

Press [ENTER].

The automatic speaker setup starts.

Auto Speaker Setup

Do not unplug Setup Mic.

Please keep quiet.

Now measuring. . .

2

Test tones are played through each speaker as Audyssey MultEQ® XT Automatic Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone.

The speaker detect results appear.

Auto Speaker Setup
Next
Retry
Cancel
:Yes	:No
	Speaker Detect Result
MOVE	ENTER ENTER

“Yes” means that the speaker was detected. “No” means that no speaker was detected.

If you agree with the results, use the Up and Down [q]/[w] buttons to select “Next”, and then press [ENTER].

The options are:

Next: Proceed to the next step. Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker

setup.

The following screen appears.

Auto Speaker Setup

Next

2

Please place microphone at next position at ear height.

ENTER ENTER

Place the setup microphone at the next position (see page 65), and then press [ENTER].

Audyssey MultEQ® XT performs more measurements. This takes a few minutes.

Auto Speaker Setup

Do not unplug Setup Mic.

Please keep quiet.

Now measuring. . .

2

66