Onkyo TX-SR876 instruction manual 106, Tone Control Settings, DSD Setting, Multiplex/Mono Settings

Advanced Setup—Continued

5	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Tone Control Settings

You can adjust the tone (bass and treble) of the front, center, surround, and surr back speakers individually. For the subwoofer, you can adjust the bass.

■Bass

You can boost or cut low-frequency sounds from –10 dB to +10 dB in 1 dB steps.

■Treble

You can boost or cut high-frequency sounds from –10 dB to +10 dB in 1 dB steps.

Notes:

•The tone control circuits are bypassed when the Direct, Pure Audio or THX listening mode is selected.

•This setting is not available when the multichannel Analog input is selected.

•This procedure can also be performed on the AV receiver by using its [TONE], [e], and [r] buttons (see page 72).

DSD Setting

■DAC Direct

This setting determines whether or not DSD (SACD) audio signals are passed through the DSP for A/V Sync, delay, etc., processing when the Pure Audio or Direct lis- tening mode is selected.

No: DSD signals are processed by the DSP (default).

Yes: DSD signals are not processed by the DSP.

Multiplex/Mono Settings

Multiplex

■Input Ch(Mux)

This setting determines which channel of a stereo multi- plex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

Main: The main channel is output (default). Sub: The sub channel is output.

Main/Sub: Both the main and sub channels are output.

Mono

■Input Ch(Mono)

This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or 2-channel analog/PCM source in the Mono listening mode.

L+R: Both the left and right channels are output (default).

L:Only the left channel is output.

R:Only the right channel is output.

■Output Speaker

This setting determines which speakers output mono audio when the Mono listening mode is selected.

C:Mono audio is output by the center speaker (default).

L/R: Mono audio is output by the front left and right speakers.

PLIIx/Neo:6 Settings

PLIIx Music(2ch Input)

These settings apply to only 2-channel stereo sources.

If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx.

■Panorama

With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode.

On: Panorama function on.

Off: Panorama function off (default).

106