Onkyo TX-SR876 Matic speaker setup again See, Speaker Settings menu appears, Normal, Bi-Amp

First Time Setup—Continued

Speaker Settings

	4		5			6			-
	TAPE	TUNER			CD
If you change these 7settings,8						9you must run the auto-
	PHONO	NET/USB			D. TUN				TV VOL
matic speaker setup again0					(see page 64).
	+10				CLEAR
	--/---
	INPUT SELECTOR
		MACRO
	1		2			3			ZONE3
		REMOTE MODE
	DVD	VCR			CD				ZONE2
					CDR/MD/DOCK					1
	TV	CABLE			NET/USB				RECEIVER
		SAT							TAPE/AMP
	DIMMER								SLEEP
2, 3				ENU	M	EN				2–6
			M				U
		OP
		T
	+
	CH			ENTER					VOL
	DISC
	ALBUM
1, 7	-		G
				UIDE	IT
	PREV				EX
		SE	T	UP	RE			N
	CH					R
						TU
	DISPLAY								MUTING
	REC			PLAYLIST					RANDOM

If the impedance of any speaker is 4 ohms or more but less than 6, set the Speaker Impedance to 4 ohms.

To use bi-amping or bridging, you must change the “Speaker Type” setting. For hookup information, see pages 27–30.

Notes:

•When bridging is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

•When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the vol- ume.

The onscreen menus shown in this manual may be slightly different from what you see on your TV.

1	Press the [RECEIVER] button,
	followed by the [SETUP] button.
	The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER]. The “Speaker Setup” menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

3

4

5

Use the Up and Down [q]/[w] but- tons to select “1. Speaker Set- tings”, and then press [ENTER].

The “Speaker Settings” menu appears.

2–1.	Speaker Settings
Speaker impedance			6ohms
Speaker Type
Front(Speaker A)			Normal
Front(Speaker B)			Not Use
MOVE	VALUE		RETURN		EXIT
		RETURN		SETUP

Use the Up and Down [q]/[w] but- tons to select “Speaker imped- ance”, and use the Left and Right [e]/[r] buttons to select:

4ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

Use the Up and Down [q]/[w] but- tons to select “Front(Speaker A)”, and use the Left and Right [e]/[r] buttons to select:

Normal:

Select this if you’ve connected your front Speakers A normally.

Bi-Amp:

Select this if you’ve connected your front Speakers A for bi-amped operation.

BTL:

Select this if you’ve connected your front Speakers A for bridged opera- tion. The BTL indicator will appear on the display.

Note:

“Bi-Amp” and “BTL” cannot be selected if “Front(Speaker B)” is set to “Bi-Amp” or “BTL”.

61