Panasonic BT-LH2170E, BT-LH2170P Submenu, Setting, MONO *2, IP mode, ANAMO *8, SCAN *2*8, I-PMODE *7, (continued), Description, SD ASPECT *2, INT. MAX. *9, EXT. MIN. *9, EXT. MAX. *9

Main Menu  (continued)

Submenu	Setting			Description
I-P MODE  *7	MODE1	Selects IP conversion mode. (see “IP mode” (→This page).)
	MODE2	[MODE1]		Intra-frame interpolation
		[MODE2]		Intra-field interpolation
MONO  *2	OFF	Switches between color and monochrome (MONO).
	ON	[OFF]	Color
		[ON]	Monochrome
		• When [ON], the [CHROMA] setting of the [PICTURE] (picture adjusting) menu is
		fixed at 0.
ANAMO  *8	OFF	With an Anamo lens and HD-SDI input, the picture is resized to Anamo
	ON	magnification. (the vertically enlarged signal can be vertically compressed and
		corrected for display).
SD ASPECT  *2	4:3	Sets the aspect ratio for SD signal input.
	16:9	[4:3]	4:3 display
		[16:9] 16:9 display
SCAN *2*8	NORMAL	Sets under-scan and normal display.
	UNDER	[NORMAL] Normal display
		[UNDER]		Under-scan
ZEBRA INT. MIN. *9	-7% to 108%	Sets the range of the ZEBRA function.
	(Factory default	Displays the minimum value of the INT. range as a percentage of the video signal.
	setting: 70%)
INT. MAX. *9	-6% to 109%	Sets the range of the ZEBRA function.
	(Factory default	Displays the maximum value of the INT. range as a percentage of the video signal.
	setting: 85%)
EXT. MIN. *9	-7% to 108%	Sets the range of the ZEBRA function.
	(Factory default	Displays the minimum value of the EXT. range as a percentage of the video signal.
	setting: 5%)
EXT. MAX. *9	-6% to 109%	Sets the range of the ZEBRA function.
	(Factory default	Displays the maximum value of the EXT. range as a percentage of the video signal.
	setting: 100%)

*2 This menu is grayed out when the same item is assigned to GPI and [GPI CONTROL] is set to [ENABLE]. *7 To use the SUB WINDOW (→page 38) function,

A Change settings after exiting the SUB WINDOW function. B It is recommended to use [MODE2] for handling fast video.

*8 [SCAN] changes are not reflected in Anamo size display.

*9 The ZEBRA function must be set according to the following conditions. [INT. MIN.] < [INT. MAX.]

[EXT. MIN.] < [EXT. MAX.]

[EXT. MIN.] ≦ [INT. MIN.]

[INT. MAX.] ≦ [EXT. MAX.]

IP mode

[MODE1] performs IP conversion using intra-frame interpolation. This monitor suppresses the delay to within 1 field.

The factory default is [MODE1].

[MODE2] performs IP conversion using intra-field interpolation.

Since interpolation is performed inside each field, this mode is suitable for checking interlace status.

28