Contacts and Settings
9.Use the following procedure to change the ID of the remote control.
1.Press and hold [·] and [#] at the same time.
2.Within 2 seconds after you release the buttons, press the number (1 to 3) corresponding to the ID that you specified for "Remote control ID" in step 4.
–1: ID1
–2: ID2
–3: ID3
10.Press [Enter].
• The dialog box disappears and the remote control ID of the
Note
•If the dialog box does not disappear, repeat the procedure above, several times if necessary. If the dialog box still does not disappear, turn the power off and then back on to cancel the settings. For details, contact your dealer.
11.Press [Home].
•The Home screen is displayed.
Performing a Network Test
You can confirm whether a network connection can be established with a particular IP address.
Note
•You cannot perform a network test from the contact list screen or the call history screen.
•You cannot refer to the contact list or the call history while you are entering an IP address.
1.Press [Menu].
•The Menu screen is displayed.
2.Use [][] to select "Settings" and press [Enter].
•The system settings screen is displayed.
3.Press [ ].
•The next page is displayed.
4.Use [][] to select "Network Test" and press [Enter].
• The network test screen is displayed.
5.Enter an IP address.
•If the IP address contains 1 or 2 digit numbers, enter these numbers as they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–Correct entry: [192.168.0.1]
–Incorrect entry: [192.168.000.001]
6.Press [R].
•The network test starts. After the network test is finished, if the network test was successful or timed out, the details of the results are displayed. If the network test failed, a message indicating the failure is displayed.
7.Press [Home].
•The Home screen is displayed.
Performing Self Diagnosis
You can check how your image will be displayed and how your voice will be heard to the other party before starting a video conference call, using your own display and speakers.
1.Press [Menu].
•The Menu screen is displayed.
2.Use [][] to select "Settings" and press [Enter].
•The system settings screen is displayed.
Document Version | Operating Manual |
69