Panasonic KX-VC500 manual Received remote control ID

Additional Information

Message

Received remote control ID

(n1). VC500 current setting is

(n2).

Press [Home] button using the correct remote control, or setup remote control as follows.

1.Press [.] and [#] at the same time

2.Within 2 seconds, press

[n2]

3.Press [Home] to finish, this message will disappear.

If this message will not disappear, please check the batteries in your remote control and try again.

Note

•The remote control ID of the remote control (1/2/3) is represented by n1.

•The remote control ID of the KX-VC500 (1/2/ 3) is represented by n2.

The IP Address is invalid. Please enter a valid IP Address.

Check the IP Address.

Cause and Solution

•The remote control IDs of the KX-VC500 and remote control do not match.

→Follow the on-screen instructions to change the remote control ID of the remote control to match that of the KX-VC500.

→If you cannot change the remote control ID of the remote control, contact your dealer.

→If multiple remote controls with assigned IDs will be used close together or if you do not want this message to be displayed, select "OFF" for "Check ID mismatch". (Page 68)

•The IP address contains an invalid value.

→Enter the IP address correctly. The correct format is XXX.XXX.XXX.XXX (dotted format decimal notation).

If the IP address contains 1 or 2 digit numbers, enter these numbers as they are. Do not enter like [.001].

Example: The IP address is [192.168.0.1].

–Correct entry: [192.168.0.1]

–Wrong entry: [192.168.000.001]

Multicast or broadcast addresses cannot be used.

•The IP address of the other party is the same as your own IP address.

•The same IP address is used for several parties in a multiple-party video conference call.

→Register the correct IP address.

→Check the IP address registered in the contact list.

94

Operating Manual Document Version 2010-10