Panasonic KX-VC500 manual LED Patterns, Screen Standby, LED pattern, Status, Notice

Preparation

LED Patterns

LEDs indicate the operational status of the KX-VC500, as follows:

LED pattern

Slow blue flashing

Blue on

Orange on

Orange flashing

Red on

Red flashing

Off

Status

•Starting up

•Idle state

•In a video conference call (including when dialing, receiving a video conference call, and being disconnected)

•Self diagnosis is being performed.

•Mismatch of field frequency*1 between the KX-VC500 and display. (After 30 seconds the flashing will stop and the KX-VC500 will restart in safe mode.)

•An error has occurred.

•Maintenance is being performed.

•A serious error has occurred.

•Power is off.

•In screen standby mode

*1 Devices such as the display or video camera operate with a particular field frequency, depending on their video format. For details on the field frequency, contact your dealer.

Screen Standby

When there is no video conference call transmission, and the KX-VC500 or remote control is not operated for more than 10 minutes (default), or when the remote control’s [Video Out On/Off] button is pressed, the KX-VC500 enters screen standby mode. Video out to the display is suspended and the status LED turns off. Screen standby mode ends when the KX-VC500 or remote control is operated, or when a video conference call is received.

Notice

•If screen standby mode ends and no image is visible, check to see if the display or video camera’s power saving settings are enabled. Check each device’s manual for more information about its power saving settings.

Note

•You can change the length of time until the KX-VC500 enters screen standby mode. (Page 74)

•The KX-VC500 will not enter screen standby mode while displaying a computer’s screen or a sub video camera’s image, even if the KX-VC500 or remote control is not operated for a period of time.

•When the KX-VC500 or remote control is operated and screen standby mode ends, the Home screen will be displayed.

•If a button is pressed on the KX-VC500 or remote control to end screen standby mode, that button’s operation is not performed in that case.

•If screen standby mode begins while editing information in the contact list or other screen, any unsaved changes will be lost.

18

Operating Manual Document Version 2010-10