About Your Projector

(14)

(22)

(15)

(23)

 

(16)

 

(17)

(24)

(18)

 

(19)

(25)

 

(26)

(20)*

 

(21)

 

Preparation

(27)

(14)<ECO> button

Display the Eco management function. (Æpage 43)

(15)<P-TIMER> button

Operate the P-timer function. (Æpage 43)

(16)<FREEZE > button

Pauses the projected image and sound tentatively. (Æpage 43)

(17)<KEYSTONE> button

Correct keystone distortion. (Æpage 44)

(18)<LENS SHIFT> button

Select the Lens Shift function. (Æpage 43)

(19)<ZOOM +/-> button

Zoom in and out the images. (Æpage 45)

(20)<P IN P> button

Operate the Picture in Picture function. (Æpage 45)

*Only for EZ570 series, EW630 series and EW530 series.

(21)ON/OFF switch

When using the remote control, set this switch to

“ON”. Set it to “OFF” for power saving when it is not in use.

(22)<SCREEN> button

Select a screen mode. (Æpage 43)

(23)<D.ZOOM> button

Select the Digital zoom +/- mode and resize the image. (Æpage 43)

(24)Input Selection buttons: <INPUT 1>, <INPUT 2>, <INPUT 3>

Select an input source (Input 1 – Input 3).

(25)<FOCUS +/-> button

Adjust the focus. (Æpage 45)

(26)<INFO> button

Operate the information function. (Æpage 45)

(27)Wired remote jack

Connect the M3 stereo mini-jack cable (not supplied) to this jack when using as a wired remote control.

Attention

zzDo not drop the remote control. zzAvoid contact with liquids.

zzDo not attempt to modify or disassemble the remote control.

Note

zzThe remote control can be used within a distance of about 5 m (16.4 ft) if pointed directly at the remote control signal receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.

zzIf there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.

zzYou can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light caused by the properties of the screen.

zzWhen the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set the projector as far from the luminous source as possible.

ENGLISH - 19