Using Remote control

Installing and Removing batteries

1111Open the cover

2222Install batteries and close the cover

 

(Insert the – side first.)

zzRemove the batteries in the reverse order of installation.

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector individually using single remote control, if unique ID number is assigned to each projector.

After setting the ID number of the projector, set the same ID number to the remote control. There are 65 different ID codes (All, Code 1~Code 64), the initial ID number is [All].

JJ Setting the ID number

1)While holding down the <MENU> button, enter a 1-digit or 2-digit number corresponding to the desired ID code number by using the number buttons 0 to 9.

2)The ID code is changed when the <MENU> button is released.

3)The examples are as follows:

Code 1= <MENU>+<1> or <MENU>+ <0> + <1> , Code 2= <MENU>+<2> or <MENU>+ <0> + <2>, Code 16= <MENU>+ <1> + <6>,

Code 64= <MENU>+ <6> + <4>

JJ Resetting the ID number

The ID code is reset to [All] (default) by pressing the <MENU> button and <0> button at the same time for 5 seconds or more.

MENU button

Attention

zz The remote control transmission is disabled during the ID code change procedure.

Note

Number buttons

zzFor details, please refer to the [Remote control] of the

 

[Setting] menu. (Æpage 66)

 

Preparation

ENGLISH - 23