Panasonic UF-333 manual Setting the TAM Interface Mode, Operation of TAM Interface Mode

Receiving Documents

Setting the TAM Interface Mode

1 Change Fax Parameter No. 16 (OUT MODE) to 2: TAM I/F. (see page 36)

2 OUT

SEP-12-1999 15:00

RCV MODE=FAX/TAM 00%

Confirm that the lamp is ON and the display is as shown to the right.

Operation of TAM Interface Mode

1

2a

When your TAM and Fax receives an incoming call, the TAM always answers the call first and then the TAM plays the OGM (Outgoing Message) recorded in your TAM to the calling station. During the time the TAM is answering the call, your fax machine will be monitoring the line to distinguish whether it is a voice or fax call.

If it is Fax call,	If it is a Voice call,
Your machine will switch the line to the	Your TAM continues to record a
fax and then begin to receive the	2b message (ICM) after playing the
documents immediately from the	OGM.
calling station.

Sample of OGM

Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the beep or if you are calling to send a fax, press the asterisk button twice on your touch tone phone now and start your machine. Thank you for calling.

Silent Detection Mode

Enables your Fax machine to switch to the Fax Mode when receiving from units that do not send fax signal (short beep) and prevents your TAM from recording blank (long silence) incoming message.

To activate this feature,

1.Change Fax Parameter No. 20 (SILENT DET.) to 2 : Valid. (see page 36)

2.Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19 (OGM LENGTH). (see page 36)

[We recommend to set the time length 5 or 6 seconds longer than the actual time length of the OGM.]

64