Panasonic UF-333 manual Troubleshooting, If You Have Any of These Problems

Troubleshooting

If You Have Any of These Problems

Mode	Symptom		Action	Page
During Installation	The display is blinking	Battery is completely discharged. This may happen at first		24
		installation. Replace the battery and re-set the clock.		124
	Document doesn't	1.	Check that your document is free of staples and paper
	feed/multiple feed		clips, and that it is not greasy or torn.
		2.	Check that your document is the right type to send	39
			through a fax machine by consulting the list on
			ºDocuments You Cannot Sendº. If your document has the
			characteristics listed, make a photocopy of your document
			and send the copy instead.
During Transmission		3.	Check that the document is loaded properly.	40
		4.	Adjust the ADF Pressure.	122
	Document jam	The information code 031 will appear on the display if the		118
		document becomes jammed.
	Does not stamp	1.	Check if Stamp LED is lit.	42
		2.	Check Fax parameter No. 04 and No. 28 settings.	35, 37
	Stamp too light	Replace stamp.		125
	Vertical lines on the	Check own copy quality. If copy is OK, your machine has no		121
	transmitted document	problem, report to the receiving party that they have a problem.
		If copy is NG, clean the Document Scanning Area.
Transmission Copy
Quality	Transmitted document	1.	Make sure the document is set face down.
	is blank	2. Check own copy quality. If copy is OK, your machine has no		121
			problem, report to the receiving party that they have a
			problem. If copy is NG, clean the Document Scanning Area.

8

During Reception

No recording paper

Recording paper jam

Recording paper doesn't advance into machine

Recording paper doesn't eject after printing

Document auto reduction doesn't work

Out of ink

The information code 010 will appear on the display if the paper runs out.

The information code 001, 002 or 016 will appear on the display if the paper gets jammed.

Make sure that there is paper in the Paper Tray. Follow instructions for loading paper.

Check to see if the recording paper is jammed inside of the machine.

Check Print Reduction settings.

The information code 015 will appear on the display if the Print Cartridge runs out of ink.

18

117

18

117

65

123

111