Panasonic UF-770 manual Troubleshooting, If You Have Any of These Problems, Sblank

Troubleshooting

IIIII I IIIIIIIIII ii iiiiiiiiiiiiiiiiiiiii

If You Have Any of These Problems

Mode Symptom Action page

ii iiii
During Installation	The display	is blinking
......................	Document	doesn't
	i feed/multiple feed

		=================	i	iiiiiii i
Battery discharged completely.				This may happen at first	25
installation, After setting the clock, the blinking will Stop,
_1	.	Checkthat your document is
			ir_eeof staples and paper
		clips, and that it is not greasy or torn,
2. Check that your			document is the right type to send through		39
		a fax machine by consulting the list on "Documents You
		Cannot Send".	if your document	has the characteristics
		ILsted, make a photocopy of your document and send the
		copy instead.

During Transmission

Document jam

Does not stamp

Stamp too light

Vertical lines on the transmitted document

3. Check that the document			is loaded properly.			40
4. Adjust the ADF Pressure			Plate.			162
The information	code 031		will appear	on the display	if the	159
document becomes jammed.
1. Check if Stamp LED is lit.						42
2, Check Fax parameter		No, 04 and No. 28 settings,				35,36
Replace stamp or refill ink.						163
Check own copy	quality.	If copy is OK,		your machine	has no	160
_roblem, report to receiving party that they have a problem. If
copy is NG, clean the Document Scanning Area,

Transmission Copy Quality

Transmitteddocument 1.		Make sure the document	is set face down.	160
*sblank	2.	Check own copy quality,	tt copy is OK, your machine	has no

problem, report to receiving party that they have a problem. If copy is NG, clean the Document Scanning Area.

i,,,,,,,,,

During Reoeption

No recording paper

Recording paper jam

Recordingpaper doesn'tadvance into machine

Recording paper

doesn't eject after printing

Recording papers are not stacked in

sequence. Machine

does not print from the last page received.

Document auto reduction doesn't work

Out of toner

The information code 010 will appear on the display if the paper			'18
runs out,
The information code 001,002	or 003 will appear	on the display	158
if the paper gets jammed,
Make sure that there is paper in the Paper Cassette. Follow			18
the instructions for loading paper,
Check to see if the recording	paper is jammed	inside of the	158
machine.
1. Check if Fax Parameter No. 65 is set to valid.			38

2.If memory becomes full during reception, the machine will 170 startto printfrom the f st page received. We recommend that optional memory is installed if this symptom occurs frequently.

Check Print Reduction settings.	61
The information code 041 will appear on the display if the Toner	16
Cartridge runs out of toner.

153