INSTALLATION
The installations described below should be made by qualified service personnel or system installers.
■Installing the Optional Hard Disk
At the time of shipment from the factory, the
To install the optional hard disk, follow the procedures below.
1.Unplug the power cord from the
2.Remove one screw on the control panel shown in the figure, then remove the panel by sliding it to the left and turned over.
FS 16
3.Remove two screws on the tray chassis in the figure, then slide out the chassis from the Disk Recorder.
FS 16
4.Insert the absorbers on to the chassis as shown in the figure.
5.Place the hard disk on the chassis, then fix it with the four screws and sleeves with the earth lug as shown in the figure.
absorber
earth lug
sleeve
6.Set the unit address with the jumper connector on the hard disk drive, as shown in the figure, for example.
7.Install the hard disk with the chassis into the Disk Recorder by sliding it from the front.
8.Plug in the power cable and interface flat cable pre- pared in the power inlet and interface connector of the hard disk as shown in the figure.
9.After installing the hard disk, secure the tray chassis and control panel by tightening the screws.
12
