ALARM SETUP
1.Move the cursor to ALARM SETUP in the
The ALARM SETUP menu shown below appears on the monitor screen.
6 ALARM SETUP |
| ||
TERMINAL TRIGGER SETUP |
| ||
AUTO RESET |
| OFF | |
ALARM | OUTPUT | 2S | |
ALARM | BUZZER | 2S | |
VIDEO | LOSS |
| ON |
VIDEO | MOTION DETECTION | OFF | |
VMD | AREA | SETUP |
|
ALARM | MODE | MULTI OUTPUT | SPOT |
|
| SPOT OUTPUT | SPOT |
2.Select an item or item parameter in the menu by press- ing the D or C button.
3.To return to the previous
■Alarm Port Setting
This item lets you designate the alarm input from the ALARM port located on the rear of the Disk Recorder.
1.Move the cursor to TERMINAL TRIGGER SETUP in the ALARM SETUP menu by pressing the D or C button, then press the SET button.
The table shown below appears on the monitor screen.
ALM CAM INPUT | ALM CAM INPUT | ||||
1CH | 1 | N.O | 9CH | 9 | N.O |
2CH | 2 | N.O | 10CH | 10 | N.O |
3CH | 3 | N.O | 11CH | 11 | N.O |
4CH | 4 | N.O | 12CH | 12 | N.O |
5CH | 5 | N.O | 13CH | 13 | N.O |
6CH | 6 | N.O | 14CH | 14 | N.O |
7CH | 7 | N.O | 15CH | 15 | N.O |
8CH | 8 | N.O | 16CH | 16 | N.O |
2.Move the cursor to the input channel editing area by pressing the A, B, D or C button.
3.Select a camera number (1 - 16) corresponding to the input for the CAM editing area by pressing the + or - button.
4.Move the cursor to the INPUT editing area by pressing the B button, then select the type of contact to meet the system requirement by pressing the + or - but- ton.
N.O: Accepts alarm input from Normally Open con- tacts.
N.C: Accepts alarm input from Normally Closed con- tacts.
The factory default setting is N.O.
5.Repeat the above steps 2 to 4 to designate the other input channels.
6.When satisfied with all of the above steps, press the SETUP/ESC button to return to the previous ALARM SETUP menu.
■Alarm Auto Reset Setting
This item lets you select the duration the Disk Recorder retains the alarm mode before resetting automatically.
1.Move the cursor to the AUTO RESET parameter in the ALARM SETUP menu by pressing the D or C button.
2.Select the desired duration by pressing the + or - button.
OFF: Disables auto reset.
1S - 30S, 40S, 50S, 1M - 5M: Selects an alarm duration between 1 second and 5 minutes.
The factory default setting is OFF.
■Alarm Output Setting
This item lets you select the output duration of the alarm signal from the ALARM port.
1.Move the cursor to the ALARM OUTPUT parameter in the ALARM SETUP menu by pressing the D or C but- ton.
2.Select the desired duration by pressing the + or - button.
OFF: Disables alarm output, regardless of an incoming alarm.
1S - 30S, 40S, 50S, 1M - 5M: Selects an alarm duration between 1 second and 5 minutes.
62
