Note: To assign the parameters 1 - 64, the specified combination cameras are equipped in the system with a PS• Data* mode.
5.Move the cursor to the SEC editing area by pressing the B button, then select the desired dwell time by pressing the + or - button.
0S: The step will not be displayed on the monitor.
1S - 30S: Selects a dwell time between 1 second and 30 seconds.
6.Repeat the above steps 2 to 5 to program the other steps.
7.When satisfied with all of the above steps, press the SETUP/ESC button to return to the previous SEQUENCE SETUP menu.
●Quad Shift Setting
This item lets you enable or disable the quad shift operation when the MULTISCREEN SELECT button is pressed.
Quad shift displays an image series such as 4A, 4B, 4C and 4D previously programmed on four screen segments.
1.Move the cursor to the QUAD SHIFT parameter in the SEQUENCE SETUP menu by pressing the D or C but- ton.
2.Select either ON or OFF by pressing the + or - but- ton.
ON: Enables the quad shift operation.
OFF: Disables the quad shift operation.
The initial factory setting is OFF.
●Quad Pattern Setup
This item lets you select the pattern to be displayed on the Multiscreen Monitor when a
The camera images can be assigned to the segments as shown below.
1.Move the cursor to QUAD PATTERN SETUP in the SEQUENCE SETUP menu by pressing the D or C but- ton, then press the SET button.
The menu shown below appears on the monitor screen.
AREA CAM | AREA CAM | |||
1 | 9 | |||
2 | 10 | |||
3 | 11 | |||
4 | 12 | |||
|
|
| ||
5 | 13 | |||
6 |
| 14 | ||
7 |
| 15 | ||
8 |
| 16 | ||
2.Move the cursor to the editing area to assign a camera by pressing the A, B, D or C button.
3.Select a camera number to be assigned by pressing the + or - button.
AREA indicates the display pattern, including the cam- era assignment and display positions as shown below.
4A-1 4A-2
4A-3 4A-4
4.Repeat the above steps 2 and 3 to assign a camera for other areas.
5.When satisfied with all of the above steps, press the SETUP/ESC button to return to the previous SEQUENCE SETUP menu.
●Sequence Timing Setting
This item lets you select between internal and external con- trol for advancing the sequence on the Multiscreen Monitor.
1.Move the cursor to the SEQ TIMING parameter in the SEQUENCE SETUP menu by pressing the D or C but- ton.
2.Select either INT or EXT by pressing the + or - but- ton.
INT: Advances a sequence by the Dwell Time that was programmed on the MULTI LIVE SEQUENCE SETUP.
EXT: Advances a sequence by the input from pin 5 of the ALARM port.
The factory default setting is INT.
58
